Two Pairs of MMA Gloves (2013)
Yellow wires = fabric pressure sensors
Green wires = square FST
Purple wires = circular FSR
Steven says:
– sensors underneath the foam please.
– the biggest FSR seems the most appropriate. Does it span the entire glove width?
– wires down to the wrist support of the glove please. If you can make them a bit longer than necessary so I have some options for positioning (an extra 20cm say). If possible, could you put the wires down the seam of the glove near the little finger?
The red box indicates the pad positioning. The centre of the pad should rest above the knuckles when you clench your fist. The yellow represents the wire positioning.
Red: current sensor positions
Green: suggested sensor positions if they should be on top of knuckles
Blue: knuckles
